Operating Instructions - Modine Manufacturing MEQ15A01 Installation, Operation And Maintenance Manual

2.4 ADJUSTING DIRECTIONAL POSITIONING
WARNING
1. Turn off the heaters electrical supply line from the main power supply.
2. Allow the heater to cool before adjusting the angle.
3. Loosen the fixing bolts on the brackets at the back of the heater; adjust the heater as desired, then re-
tighten the fixing bolts.
Notice : The unit produces radiant heat that warms people and objects rather than the air around them. Install
the heater at an angle which points the reflector at the target space. Do not point the heater at windows or vacant
spaces, as the heat will not be delivered to the occupants.
Caution! The heater must be properly installed before it is used.
Caution! When the heater is not in use for extended periods of time, be sure to set the operating mode to the
"OFF" position.
The heater has two modes of operation, these two modes can be selected using the button on the right side of
the heater.
Never attempt to move or adjust the heater angle while it is running. Personal
injury could result.
INCORRECT

3 - OPERATING INSTRUCTIONS

Remote Mode
CORRECT
PCB bypass Mode
OFF
7