Maintenance - Modine Manufacturing MEQ15A01 Installation, Operation And Maintenance Manual

Notice:
1. Use 2 pieces AAA, 1.5V batteries (not included) in the remote control. Remove the batteries when not in use for an
extended period of time to increase battery life.
2. The heater can be still used normally in the event the remote control is misplaced, however it must be used in PCB
bypass mode where the heater will run fully on. Contact your local authorized Modine Dealer for remote
replacement.
3. The remote-control function may not work if there is a barrier between the remote control and heater.
4.
Replace the batteries as required to ensure correct remote functionality.
1. Allow the heater and the emitter to cool down before handling.
2.
Installation and maintenance must be performed by a qualified technician.
3.
Turn off the power before beginning maintenance.
4.
Do not attempt to service or repair the unit while it is running.
5. Should the heater be dropped or damaged or malfunction at any time, immediately turn off the main
power source and do not use it until it has been examined by an authorized service facility.
6. All other servicing should be performed by qualified service personnel.
Notice: Do not touch the emitter with bare hands. Wearing soft cotton gloves is highly recommended. Finger
prints will burn into the Tungsten emitter during use and cause premature heater failure. If the emitter is
anidvertently touched, or if it needs to be cleaned, carrefully wipe it using rubbing alcohol or methylated spirits.
4.1 CLEANING
To keep the heater running at peak performance and prevent premature failure, the emitter lamp and reflector
should be cleaned as required. Buildup of dust on these components will accelerate aging. In seaside
environments, salt spray may collect on these components. Salt spray should be removed regularly.
To clean the reflector or emitter lamp, follow these steps:
1. Turn the power to «OFF» and disconnect the heater from the main power supply.
2. Remove screws from the left side cover and slide the perforated front grille out of the heater body.
3. Carefully wipe the reflector with a soft, lint-free cloth. Do not use abrasive material!
4.
After cleaning, be sure to properly reinstall the heater grille.

4 - MAINTENANCE

WARNINGS
11