Operating Instructions; Operation Of The Remote Control - Modine Manufacturing MEQ15A01 Installation, Operation And Maintenance Manual

Caution! The heater must be properly installed before it is used.
3.1 REMOTE CONTROL
The remote control must be pointed in the direction of the receiver on the heater body (located on the front
face) and must be used within a maximum distance of 6 m.
The heater has the option to run at 50% or 100% power. Each emitter is controlled separately using the Left and
Right arrows on the remote. Pressing the L button (L) will turn the left emitter on. Pressing L again will turn the
left emitter off. Pressing the R button (R) will turn the right emitter on. Pressing R again will turn the left emitter
off. Pressing the (MAX) button will turn both emitters on, pressing it again will turn both emitters off.
3.1.1

OPERATION OF THE REMOTE CONTROL

Notice:
1. Use 2 pieces AAA, 1.5V batteries (not included) in the remote control. Remove the batteries when not in use for an
extended period of time to increase battery life.
2. Contact your local authorized Modine Dealer for remote replacement.
3. The remote-control function may not work if there is a barrier between the remote control and heater.
4.
Replace the batteries as required to ensure correct remote functionality.
3 -

OPERATING INSTRUCTIONS

Symbol Description
L
Turns the LEFT lamp on and off
The heater goes directly to the highest heating level
MAX
(short delay on start).
R
Turns the RIGHT lamp on and off
To switch the heater ON: Press On.
The heater has a soft start function using only 16% of
ON
maximum power. 4 seconds after the heater has been
turned on, the heater will automatically switch to 100%
power.
To switch the heater OFF: Press OFF. The heater will
OFF
switch to Standby mode (the receiver indicator will light
up).
10