WARNING
This heater is for use on 120-volt circuits. The cord has a plug as shown in image (A) in Figure 60.1 below. An adapter
shown at C must be used to connect three-blade grounding-type plugs to two-slot receptacles. Adapters should not be
used if a three-slot grounded receptacle is available. The green grounding lug extending from the plug must be
connected to a permanent ground such as a properly grounded outlet box.
NOTE: This heater may be hard wired by a licenced electrician per NEC or Local codes. To hard wire, a licenced
electrician may remove the plug and hard wire the heater to a properly grounded junction box.
WARNING
Due to ongoing product improvements, specifications and dimensions are subject to change and correction without notice and without
incurring obligations. Determining the application and suitability for use of any product is the responsibility of the installer. Additionally,
the installer is responsible for verifying dimensional data on the actual product prior to beginning any installation preparations.
Incentive and rebate programs have precise requirements as to product performance and certification. All products meet applicable
regulations in effect on date of manufacture; however, certifications are not necessarily granted for the life of a product. Therefore, it is
the responsibility of the applicant to determine whether a specific model qualifies for these incentive/rebate programs.
Manual Revision: A1:2023-11-01
5 - GROUNDING INSTRUCTIONS
Connection to GFCI protected outlet is recommended for outdoor, exposed
environments and/or as required by local, state and National Electrical Code
(NEC) requirements.
FAILURE TO USE A GFCI PROTECTED OUTLET COULD RESULT IN FIRE OR
ELECTRIC SHOCK!
Modification of the supplied cord for hardwire purpose may only be completed
by CERTIFIED ELECTRICIANS, and modification must satisfy local and NEC
requirements. Incorrect modifications could result in electric shock or fire!
12
Need help?
Do you have a question about the MEQ15A01 and is the answer not in the manual?
Questions and answers