Calibrating Infeed Table - Grizzly G0654 Owner's Manual

Calibrating Infeed
Table
The infeed table height is calibrated by adjusting
the depth scale and depth stop knob.
Tools Needed
Straightedge ...................................................... 1
Phillips Head Screwdriver ................................. 1
Calibrating Depth Scale
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
To calibrate the depth scale:
1. Set the outfeed table height as described in
Setting Outfeed Table Height on Page 21.
2. Move the cutterhead guard out of the way.
3. Place a straightedge across the infeed and
outfeed tables.
4.
Adjust the infeed table until it is level with the
outfeed table, as illustrated in Figure 71.
������������
�������
Figure 71. Infeed table adjusted even with
outfeed table.
-40-
5.
Using a screwdriver, adjust the scale pointer
exactly to "0", as shown in Figure 72.
Depth Stop
Knob
Qty
Figure 72. Depth scale and depth stop knob.
Depth Stop Knob
A depth stop knob (Figure 72) on the depth scale
assembly allows the operator to set the maximum
depth of cut to
To engage the knob, adjust the table height to
until the knob clicks into place. To disengage the
knob, pull it out and adjust the table to the desired
height.
������
Depth Scale
⁄ ".
1
8
G0654 6" Jointer with Mobile Base
Pointer
⁄ "
1
8