Flange Screws #10-24; Flange Screws #10-24 X " (Switch) - Grizzly G0654 Owner's Manual

17. Loosen the motor or cutterhead pulley set
screws and move the pulleys in or out as
needed to bring them into alignment.
18. Tighten the pulley set screws.
19. Lower the motor to increase belt tension,
tighten the motor mount bolts and recheck
pulley alignment.
20. Install the front panel (Figure 20) onto the
cabinet with (10) #10-24 x
making sure the panel is installed on the
same side as the motor fan.
x 10
Figure 20. Front panel installed.
21. Install the switch assembly onto the front
panel with four #10-24 x
shown in Figure 21.
Figure 21. Switch installed.
-18-
⁄ " flange screws,
3
8
⁄ " flange screws, as
3
8
22. Attach the dust port to the left cabinet panel
and dust chute with four #10-24 x
screws, as shown in FIgure 22.
Figure 22. Dust port installed.
23. Thread two #10-24 x
way into the cabinet right panel, slide the
push block holder over the screws, secure
the arm with a third #10-24 x
then tighten all the screws (Figure 23).
Figure 23. Push block holder installed.
G0654 6" Jointer with Mobile Base
3 ⁄ " flange
8
⁄ " flange screws half
3
8
⁄ " flange screw,
3
8
Arm