Resetting Your Workstation; Displaying And Setting Paths; D–1. System Paths - HP J Class Owner's Manual

Resetting Your
Workstation
Displaying and
Setting Paths
The path command sets
and displays the hard-
ware address of a speci-
fied device attached to
the I/O bus of your
workstation.
D-12
To reset your workstation, follow the directions in "Accessing the
Boot Console Interface" earlier in this appendix, and then type the
following at the prompt:
Main Menu: Enter a command or a menu > reset
A path is the hardware address of a device that is attached to the I/O
system of your workstation. The path command sets the system paths
shown in Table D–1:
Path Type
primary or pri
alternate or alt
To display the current settings for the system paths, type the follow-
ing at the prompt:
Main Menu: Enter a command or a menu > path
The paths are displayed in Mnemonic Style Notation, as shown in
Table D–2.
Table D–1. System Paths
Device
Your workstation's default boot device
(usually the root disk)
Your workstation's alternate boot device
(usually a DDS-format tape device)
Enter
Enter