Setting The Timer - Aiwa NSX-A999 Operating Instructions Manual

The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press one of the function buttons to select a
source.
If TUNER BAND is pressed, the band cannot be selected in
this step.
Press TIMER repeatedly until @ appears on the
display.
Time and audio source name flash alternately.
6
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or Il.
Turning MULTI JOG changes both the hour and the minute.
< or - is also available instead of MULTI JOG, Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated period.
The duration can b@set between 5 and 240 minutes
minute steps.
+< or - is also available instead of MULTI JOG,
5
6
7
Adjust the volume.
#
The source sound will play at the volume level set in this step
when the power is turned on by the timer.
#"
If the volume level is set to 21 or higher, however, it will
$gj;
E
.!,,!,
automatically be set to 20 when the power is turned on. ~, ~:~
Prepare the source.
~;?w:'
To listen to a CD, load the disc to be played first on tray 1,
.;*;
To listen to a tape, insert the tape into deck 1 or 2.
8
. ,7
To listen to the radio, tune in to a station.
J
u
Press POWER to turn off the power.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
m
You can change the source that was selected in step 1 by pressing
one of the function buttons before pressing ENTER or II in step
3.
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 4 seconds,
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4,
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that ~ disappears.
To restore the timer standby mode, press again to display ~.
Using the unit while the timer is set
You can use the unit normally after setting the timer,
Before turning off the power, "carry out st;p 5 and 6.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit, Use an external timer,
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press either TUNER BAND or VIDEO/AUX to select a source,
then press TIMER repeatedly until OREC lights up on the
display. Within 6 seconds, carry out the steps of "SETTING
THE TIMER" from step 3 and insert the tape to be recorded on
into deck 2 after step 6.
in
5-
m
When the power-economizing mode (page 7) has been turned
on, the timer recording volume level will be O (minimum level).
* You cannot use the timer function to record from a CD or tape.
The duration will be automatically set after 4 seconds. h will
also be set if ENTER or I I is pressed within 4 seconds after
step 4.
ENGLISH
27