Garmin G1000:Socata Pilot's Manual page 398

AUTOMATIC FLIGHT CONTROL SYSTEM
CHANGING THE AIRSPEED REFERENCE
The Airspeed Reference (shown in both the AFCS Status Box and above the Airspeed Indicator) may be
adjusted by:
• Using the NOSE UP/DN Wheel
• Pressing the CWS Button, hand-flying the aircraft to attain a new Airspeed Reference, then releasing the
CWS Button
If the Selected Altitude is reached during CWS maneuvering, the Altitude Reference is not changed.
NOTE:
To adjust the Altitude Reference in this case, the CWS Button must be pressed again after the Selected
Altitude is reached.
Airspeed Reference units can be manually toggled between IAS and Mach units using the SPD Key. When
the FLC Airspeed Reference is displayed in Mach, the Airspeed Reference Bug is displayed on the Airspeed
Indicator at the IAS corresponding to the selected Mach target speed and the current Mach number is shown
below the Airspeed Indicator.
Airspeed
Reference
Airspeed
Reference
Bug
Current
Mach
Number
7-14
Flight Level
Change Mode
Active
Figure 7-12 Flight Level Change Mode (Mach)
Garmin G1000 Pilot's Guide for the Socata TBM 850
Airspeed
Selected
Reference Altitude Capture
(Mach) Mode Armed
190-00709-00 Rev. A