Stormscope (Optional); Setting Up Stormscope On The Navigation Map - Garmin G1000:Socata Pilot's Manual

HAZARD AVOIDANCE
6.3 WX-500 STORMSCOPE (OPTIONAL)
The Stormscope system is not intended for hazardous thunderstorm penetration. Weather information
NOTE:
on the G1000 MFD is approved for weather avoidance only. Refer to the WX-500 User's Guide for a detailed
description of Stormscope operation.
L-3 STORMSCOPE ® WX-500 Lightning and GDL 69/69A XM ® Satellite Weather Lightning are
NOTE:
mutually exclusive .
The following pages can display Stormscope data:
• PFD Inset Map
• Stormscope Page
• Navigation Map
To display Stormscope data on any map besides the Stormscope Page, select the MAP Softkey (or the INSET
Softkey for the PFD Inset Map), then select the STRMSCP Softkey. These pages can also display cell or strike data
using the yellow lightning strike symbology shown in Table 6-5.

SETTING UP STORMSCOPE ON THE NAVIGATION MAP

Setting up Stormscope options on the Navigation Map:
1) On the Navigation Map Page, press the MENU Key.
2) With 'Map Setup' selected (Figure 6-56), press the ENT Key.
3) Turn the small FMS Knob to display the group selection window. Turn the small FMS Knob to select 'Weather'
(Figure 6-57), and press the ENT Key.
4) Turn the large FMS Knob to highlight and move between the product selections.
5) When an item is highlighted, turn the small FMS Knob to select the option.
6-50
Lightning Age
Strike is less than 6 seconds old
Strike is between 6 and 60 seconds old
Strike is between 1 and 2 minutes old
Strike is between 2 and 3 minutes old
Table 6-5 Lightning Age and Symbols
Garmin G1000 Pilot's Guide for the Socata TBM 850
• AUX - Trip Planning Page
• Nearest Pages
Symbol
190-00709-00 Rev. A