Garmin G1000:Socata Pilot's Manual page 71

TURN RATE INDICATOR
The Turn Rate Indicator is located directly above the rotating compass card. Tick marks to the left and right
of the lubber line denote half-standard and standard turn rates. A magenta Turn Rate Trend Vector shows the
current turn rate. The end of the trend vector gives the heading predicted in 6 seconds, based on the present
turn rate. A standard-rate turn is shown on the indicator by the trend vector stopping at the standard turn
rate tick mark, corresponding to a predicted heading of 18˚ from the current heading. At rates greater than 4
deg/sec, an arrowhead appears at the end of the magenta trend vector and the prediction is no longer valid.
BEARING POINTERS AND INFORMATION WINDOWS
When the Arc HSI is displayed, the Bearing Information windows and pointers are disabled.
NOTE:
Two bearing pointers and associated information can be displayed on the HSI by pressing the PFD Softkey
then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS, ADF). The pointers
are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective information
window to indicate the pointer type. The bearing pointers never override the CDI and are visually separated
from the CDI by a white ring (shown when bearing pointers are selected but not necessarily visible due to
data unavailability).
DME Information Window
Distance to
Bearing Source
Bearing
Source
Bearing 1 Information Window
190-00709-00 Rev. A
Half-standard
Turn Rate
Standard
Turn Rate
Figure 2-28 Turn Rate Indicator and Trend Vector
Tuning Mode
Frequency
Distance
Station
Identifier
Pointer
Icon
Figure 2-29 HSI with Bearing and DME Information
Garmin G1000 Pilot's Guide for the Socata TBM 850
Bearing 1 Bearing 2
Pointer Pointer
FLIGHT INSTRUMENTS
Arrow Shown
for Turn Rate
> 4 deg/sec
No
Waypoint
Selected
Pointer
Icon
Bearing 2 Information Window
Bearing
Source
2-17