Getting Your Network Information; Setting The Fast Ethernet Port Ip Address - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Chapter 4 Powering On the Cisco VG224 Voice Gateway
Perform the following initial configuration procedures, as applicable:
•
•
•

Getting Your Network Information

Before you begin the configuration process, get the IP address for the 10/100BASE-T ports.

Setting the Fast Ethernet Port IP Address

To configure the Cisco VG224 voice gateway remotely through a Fast Ethernet connection, connect the
10/100BASE-T port to a live Ethernet connection using a standard Ethernet cable with RJ-45 connectors;
then complete this procedure to set the IP address for the port. After setting this address, you can
configure the Cisco VG224 voice gateway remotely through a Telnet connection.
Command
Step 1
Router# configure terminal
Step 2
Router(config)# enable password password
Step 3
Router(config)# interface FastEthernet 0/0
Step 4
Router(config-if)# ip address IP-address subnet-mask
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# exit
Step 7
Router(config)# line vty 0 4
Step 8
Router(config-line)# password password
Step 9
Router(config-line)# end
Step 10
Router# copy system:running-config nvram:
startup-config
OL-5006-04
Getting Your Network Information, page 4-3
Setting the Fast Ethernet Port IP Address, page 4-3
Verifying and Saving Your Configuration, page 4-4
Purpose
Enters global configuration mode.
Sets a password for the privileged EXEC mode.
Enters interface configuration mode.
Enters the IP address and subnet mask for the Fast
Ethernet (10/100BASE-T) port.
Activates the 10/100BASE-T port.
Returns to global configuration mode.
Enters line configuration mode.
Sets a password for remote access to the
Cisco VG224.
Returns to privileged EXEC mode.
Saves the configuration.
Cisco VG224 Voice Gateway Hardware Installation Guide
Initial Configuration Procedures
4-3