Verifying The Initial Configuration - Cisco CISCO871-K9 - 871 Integrated Services Router Hardware Installation Manual

Chapter 5 Initial Configuration
Press Return to display the Router> prompt.
Step 3
...
flashfs[4]: Initialization complete.
Router>
Enter privileged EXEC mode.
Step 4
Router> enable
Router#
For configuration using the CLI, see the applicable configuration procedures in the
Step 5
Cisco 870 Series Access Routers Software Configuration
Verify the initial configuration. See the
Step 6
procedures.

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, perform the following tests:
•
•
•
After you have completed and verified the initial configuration, you can configure your Cisco router for
specific functions.
What to Do Next
For information and instructions on how to perform additional configurations for the router, see the
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration
OL-5331-01
To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter the show interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide
Guide.
"Verifying the Initial Configuration"
Verifying the Initial Configuration
Cisco 850 Series and
section for verification
Guide.
5-5