What To Do Next; Chapter 4 Router Cabling Procedures - Cisco CISCO871-K9 - 871 Integrated Services Router Hardware Installation Manual

What to Do Next

Figure 3-3
1
Perform the following steps to mount the PoE module on a wall:
Select a location on the wall on which you wish to mount the PoE module. See
Step 1
locations of the mounting brackets on the bottom panel.
Mark on the wall where the mounting screws will be anchored, making sure that the marks line up
Step 2
vertically. Drill two holes 1.70 in. (4.32 cm) apart on the wall, using the drill bit size that is specified by
the screw or hollow-wall anchor manufacturer.
Anchor the screws into the wall, leaving 1/8 in. (0.32 cm) between the screw head and the wall for
Step 3
mounting the PoE module.
Step 4 Hang the PoE module on the wall, and secure the screws into the latches of the mounting brackets.
Place the power supply on a horizontal surface.
Step 5
What to Do Next
Connect devices to the router by following the instructions in
Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide
3-6
Mounting Brackets on the Bottom Panel of the PoE Module
Mounting brackets
Chapter 3
1
1
2
Distance between the mounting brackets
(1.70 in. [4.32 cm])
Router and PoE Module Mounting Procedures
2
Figure 3-3
Chapter 4, "Router Cabling Procedures."
for the
OL-5331-01