extronics iSCAN X4C-2-P Operating Instructions Manual page 6

Notes on • Electrical plants are subject to certain regulations concerning
installation
• In the hazardous area it is the operator's responsibility to carry
Caution Devices fitted with laser fall under standards US 21 CFR 1040.10
on laser
and EN 60825-1. The laser's classification is stated on a plate
devices
affixed to the device. Class 1 lasers are deemed inherently safe
during normal use, but users must not look directly into the light
source. The following declaration is required by American and
international laws:
Usage of control elements, adaptations or the use of procedures
that differ from these instructions may result in a dangerous
exposure to laser beams.
Class 2 lasers use a visible low-voltage LED. As with any source
of bright light, such as the sun, the user should avoid looking
directly into the light. Brief exposure to a class 2 laser is deemed
not dangerous.
Maintenance Provided the device is operated and assembled according to
instructions and the ambient requirements are being met
continuous maintenance is not necessary.
Servicing Operators of electric equipment in hazardous areas are obliged to
have them serviced by qualified electricians (IEC 60079-19 and
IEC 60079-17).
Repairs Repairs may only be carried out by the manufacturer or by persons
trained and commissioned for this purpose by the manufacturer.
The device is closed ex-factory. It may only be opened in the factory by
specifically trained personnel.
Software For instructions on how to install the software at the PC please
installation
refer to the manual issued by SICK.
Operation Before operating the device you must ensure that all necessary
components are available.
installation and operation (e.g. RL 99/92/EG, RL 94/9EG, or
the national rules such as
IEC 60 079-14 and VDE 0100).
out any repair and maintenance in compliance with applicable
rules.
6