Safety Information; Summit Xgm-2Xn Option Card - Extreme Networks Summit X250e-24t Hardware Installation Manual

Summit Option Cards

Safety Information

CAUTION
Pluggable optical modules may become very hot after prolonged use. Take care when removing a pluggable optical
module from the option card. If the pluggable optical module is too hot to touch, disengage the module and allow it
to cool before removing it completely.
Only trained service personnel should perform service to Extreme Networks switches and their
components. Trained service personnel have read all related installation manuals, have the technical
training and experience necessary to be aware of the hazards to which they are exposed in performing a
task, and are aware of measures to minimize the danger to themselves or other persons.
Before installing a Summit option card into your network:
Read the latest installation and safety information in this chapter and the section specific to the optic
●
type you are installing.
See Appendix A, "Safety Information,"
●
Specifications,"
WARNING!
When working with laser optic modules, always take the following precautions to prevent exposure to hazardous
radiation:
●
Never look at the transmit LED/laser through a magnifying device while it is powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are powered on.
● Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the beam
when optic connections are unplugged.
●
Never alter, modify, or change an optic device in any way other than suggested in this document.

Summit XGM-2xn Option Card

The Summit XGM-2xn option card allows you to add up to two 10-gigabit XENPAK modules to the
following switches:
Summit X450-24x switch, running ExtremeXOS 11.2.0 (or later)
●
Summit X450-24t switch, running ExtremeXOS 11.2.0 (or later)
●
The Summit XGM-2xn option card is compatible with the following 10-gigabit XENPAK modules:
SR XENPAK module, operating in the 850 nm range
●
LR XENPAK module, operating in the 1310 nm range
●
ER XENPAK module, operating in the 1550 nm range
●
ZR XENPAK module, operating in the 1550 nm range
●
LX-4 XENPAK module, operating in the 1269-1355 nm range
●
For more information about these XENPAK modules, refer to the Extreme Networks Pluggable Interface
Modules Installation Guide.
148
for additional safety information and
for additional information regarding regulatory compliance certifications.
Appendix B, "Technical
Summit Family Switches Hardware Installation Guide