Installing An Eps-C Chassis - Extreme Networks Summit X250e-24t Hardware Installation Manual

NOTE
An AC power cord is not provided with the EPS-600LS power module. See
page 170 for information about selecting a power cord.
Each EPS-C chassis is shipped with a special redundant power supply cord for connection to the Summit switch.
Make sure that the EPS-C chassis is installed in the rack system before installing an EPS-600LS unit.

Installing an EPS-C Chassis

CAUTION
Do not use the rack mount brackets to suspend the EPS-C from under a table top or desk, or to attach the EPS-C
unit to a wall.
The EPS-C is intended for use only with a Summit X450e-48p or X250e-48p switch. You can install the
EPS-C above or below the Summit switch (see
Figure 109: EPS-C and Summit Switch
EPS-C
Stack 10G 1 2 4 6 8 10 12
3 5 7 9 11 13
1 1
2 2
MGMT
STACK NO.
FAN
PSU-1
PSU-E
To rack-mount the EPS-C:
1 Place the EPS-C upright on a secure work surface.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a rack mount bracket over the mounting holes on one side of the unit.
b Insert the provided screws and fully tighten them using a screwdriver (see
Summit Family Switches Hardware Installation Guide
Figure
ESP-C
14 16 18 20 21 22 24 26 28 30 32 34
15 17 19 23 25 27 29 31 33
Summit X450e-48p Switch
"Selecting Power Supply Cords" on
109).
PSU1 PSU2 PSU3
DC good
AC good
35 36 38 40 42 43 44 45 46 48 46X 47X 48X Solid ON = Link
37 39 41 47 45X
Blinking = Activity
Shared Ports
ESP-C_02
Figure 110).
141