Removing Summit X650 Series Switches; Removing The Power Supplies - Extreme Networks Summit X250e-24t Hardware Installation Manual

Figure 88: Connecting the DC Power Cables (Part 2)
RTN
-48V
(+)
(–)
SH_112
6 Connect the cables to the DC source voltage, using hardware appropriate to the installation site and
following local and national electrical codes.
7 Energize the DC circuit.
Leave the ESD strap permanently connected to the rack, so that the strap is always available when you
need to handle ESD-sensitive components.

Removing Summit X650 Series Switches

This section provides procedures for removing a Summit X650 series switch from a two-post or
four-post equipment rack.

Removing the Power Supplies

Before you remove a Summit X650 series switch from the rack, remove all installed power supplies, as
described in this section.
117
Summit Family Switches Hardware Installation Guide