Installing An Eps-160 Power Supply Into An Eps-T; Connecting The Eps-160 Power Supply To The Switch - Extreme Networks Summit X250e-24t Hardware Installation Manual

To rack mount the EPS-T:
1 Place the EPS-T upright on a stable surface, with the front facing you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a mounting bracket over the mounting holes on one side of the EPS-T (see
b Insert the screws and fully tighten them using a screwdriver.
Figure 95: Attaching the Mounting Bracket
c Repeat steps a and
4 Slide the EPS-T into a 19-inch rack and secure it using appropriate rack-mount screws.

Installing an EPS-160 Power Supply into an EPS-T

To install an EPS-160 power supply into the EPS-T:
1 Remove the EPS-160 power supply from the packing material.
2 Remove the cover plate from an empty slot on the EPS-T.
3 Insert the power supply into the empty slot on the EPS-T.
4 Tighten the captive thumbscrews to secure the power supply to the EPS-T.
5 Connect the EPS-160 power supply to the Summit switch, following the instructions in the next
section, "Connecting the EPS-160 Power Supply to the

Connecting the EPS-160 Power Supply to the Switch

One end of the EPS-160 redundant power cord has a keyed connector to ensure correct alignment of the
connector (Figure 96). The key is a plastic tab on the cord connector housing that fits into the EPS-160
unit to ensure correct alignment of the connector.
Summit Family Switches Hardware Installation Guide
ES4K026
b for the other side of the EPS-T.
Switch."
Figure 95).
127