Adsl Led; Problems With The Web Interface - Encore ENDSL-A2+R2 User Manual

Adsl2+ modem one port full-rated router
Hide thumbs Also See for ENDSL-A2+R2:
Table of Contents

Advertisement

5.1.3 ADSL LED

The ADSL LED on the front panel does not light up.
STEPS
1
Check the telephone wire and connections between the router ADSL port and the wall
jack.
2
Make sure that the telephone company has checked your phone line and set it up for
ADSL service.
3
Reset your ADSL line to reinitialize your link to the DSLAM.
4
If these steps fail to correct the problem, contact your local distributor for assistance.

5.2 Problems with the Web Interface

I cannot access the web Interface.
STEPS
1
Make sure you are using the correct IP address of the router. Check the IP address of
the router.
2
Make sure that there is not a console session running.
3
Check that you have enabled web service access. If you have configured a secured
client IP address, your computer's IP address must match it. Refer to the chapter on
remote management for details.
4
For WAN access, you must configure remote management to allow server access from
the WAN (or all).
5
Your computer's and the router's IP addresses must be on the same subnet for LAN
access.
6
If you changed the router's LAN IP address, then enter the new one as the URL.
7
Remove any filters in LAN or WAN that block web service.
The web Interface does not display properly.
STEPS
1
Make sure you are using Internet Explorer 5.0 and later versions.
2
Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the Delete Files ...
button.
When a Delete Files window displays, select Delete all offline content and click OK.
(Steps may vary depending on the version of your Internet browser.)
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
76

Advertisement

Table of Contents
loading

This manual is also suitable for:

Endsl-a2+4r2

Table of Contents