Connecting To Video Equipment (Video, S-Video, Component And Rgb Scart) - Eiki LC-XGC500A Owner's Manual

Connecting to Video Equipment (Video, S-video, Component and RGB Scart)

Cables used for connection
• Video Cable (RCA x 1)
• S-VIDEO Cable
• DVI-Digital Cable
(Cables are not supplied with the projector.)
Composite
S-video
Video
Output
Output
S-video DVI-Digital
RCA
cable
cable
cable
S-VIDEO VIDEO
✔Notes:
• The S-VIDEO jack connection overrides the VIDEO jack
connection when selecting AUTO in the Input Menu (p.35).
• When the Standby mode is set to "Eco" in the Setting,
MONITOR OUT and AUDIO OUT are disabled. (p.55)
Unplug the power cords of both the projector and external
equipment from the AC outlet before connecting cables.
• VGA-Scart Cable
• BNC Cable
Digital Output
(HDCP RGB Scart
compatible) 21-pin Output
VGA-
Scart
cable
ANALOG
DIGITAL
IN
(DVI-D)
Component Video
Composite
Video
Refer to the
(Y Pb/Cb Pr/Cr)
Output
Monitor Out
Signal Table
(next page).
BNC
VGA-
BNC
cable
Scart
cable
cable
MONITOR
Y Pb/Cb Pr/Cr
VIDEO
OUT
Installation
Output
21