Connecting The Power Supply - Cisco 761M Installation Manual

Connecting the Power Supply

Warning
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 16A international) is used on the phase conductors
(all current-carrying conductors).
Warning
connected to earth ground during normal use.
To connect the power supply, complete the following steps:
Step 1
Step 2
Step 3
Figure 3-5 Connecting Power Supply (Cisco 765 shown)
Desktop power supply
This product relies on the building's installation for short-circuit
This equipment is intended to be grounded. Ensure that the host is
Connect the round end of the power supply cable to the black circular power
connector on the rear panel of your router.
Connect the black power supply cord to the black power supply.
Connect the power supply cord to an electrical outlet. (See Figure 3-5.)
10 BA SE T
CO NF IG
Li nk
N O D E
H U B
IS D N S /T
S
0
+5 V --- 1.5
A +/- 5%
-30 V- -- 0.2
A +/- 25 %
DC power input
Installing Your Router 3-9