Cisco 761M Installation Manual page 92

Downloading Software
Step 3
Step 4
Step 5
B-6
Cisco 700 Series Router Installation Guide
Enter y to continue:
Are you sure? y
You are prompted to select the baud rate.
BOOT version 2.0(1) 04-16-96 12:03:06
Copyright (c) 1993-1996. All rights reserved.
Ready to upload new firmware into flash. Select baud rate:
1 - 300 baud
2 - 1200 baud
3 - 2400 baud
4 - 4800 baud
5 - 9600 baud
6 - 19200 baud
7 - 38400 baud
8 - 57600 baud
9 - 115200 baud
Enter 5.
Hyperterminal does not allow you to change baud rate on-the-fly;
Note
however, if you are using another terminal emulation software, you might be
able to do so to increase the speed of the download.
To change the baud rate, enter the number that corresponds to the desired baud
rate. Do not press the Return key. Set the baud rate on the terminal to match the
selected baud rate. Set the protocol to ASCII on the terminal. Press Return.
Download the file containing the new software to the router by following the
prompts on your terminal.
Select Transfer>Send text file. The system loads the file on the router. (The
LINE LED blinks throughout the loading process.)
When the download is complete, the LINE LED turns off, and the RDY LED
turns on.