Introduction; Muxlab Ethernet Switch Setup Requirements - Cisco SG300-10P Quick Setup Manual

1.

Introduction

This document covers the basic setup requirements for a Cisco Ethernet Switch. The
setup examples and screen shots shown are for the Cisco model SG300-10P, but these
instructions are similar and applicable to other Cisco Ethernet Switch models.
2.

MuxLab Ethernet Switch Setup Requirements

All MuxLab AV over IP Transmitters and Receivers require IGMP support to be enabled
on the Ethernet Switch, and a select number of MuxLab units also require Jumbo
Frames to be enabled.
Also note that all models below work on a 1G Ethernet Switch, except for the 500760,
which requires a 10G Ethernet Switch.
The below table specifies the IGMP and Jumbo Frames requirement per MuxLab AV
over IP Transmitter / Receiver model.
AV over IP
Model
500752
500753
500754
500755
500755-AMP
500756
500757
500758
500759
500760
500762
500770
500771
© MuxLab Inc. 2017
Ethernet Switch
BW Required
1G
1G
1G
1G
1G
1G
1G
1G
1G
10G
1G
1G
1G
Cisco Ethernet Switch Quick Setup Guide
IGMP
Required
X
X
X
X
X
X
X
X
X
X
X
X
X
Jumbo Frame
Required
X
X
X
X
3