Troubleshooting - cecotec CONGA 7490 ULTIMATE GENESIS Instruction Manual

- To replace the battery, follow the instructions below:
1. Unscrew the screws on the lower housing, remove the latter, and take out the battery.
2. Insert the new battery.
3. Put the battery and the lower housing back in place and re-tighten the screws.

5. TROUBLESHOOTING

Problem
The robot vacuum
cleaner does not switch
on or does not clean.
The robot vacuum
cleaner cannot
charge or return to
the charging base.
The robot vacuum
cleaner does not
work properly.
The robot vacuum
cleaner makes a
strange noise
during operation.
The robot vacuum
cleaner does not
clean efficiently or
doesn't pick up all the
dirt.
Possible cause and solution
The robot vacuum cleaner does not work when battery is
low. Allow it to charge before operation.
The room temperature is below 0 ºC or above 40 ºC.
There are too many obstacles near the charging base.
Relocate the charging base to an area free of obstacles.
Clean the charging terminals of both the charging base and the
robot vacuum cleaner.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the
charging base. Place it closer and try again.
Turn off the robot vacuum cleaner and turn it on again.
Reset the robot vacuum cleaner by pressing the side
Reset button.
The main brush, side brush, or omnidirectional wheel are
blocked or tangled. Stop the robot vacuum cleaner and
clean them.
The tank is full. Empty it and clear the high-efficiency filter if
it is blocked.
The high-efficiency filter is blocked. Clean it.
The main brush is blocked or tangled. Clean it.
CONGA 7490 ULTIMATE GENESIS
ENGLISH
50