Scheppach FS3600 Translation Of Original Instruction Manual page 27

Service
a. Only have your power tool repaired by qualified
specialists and only with original spare parts.
This ensures that safety of the electric tool is
maintained.
Do not stare into beam
Protect yourself and your environment from acci-
dents using suitable precautionary measures!
• Do not look directly into the laser beam with unpro-
tected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
• Caution - methods other than those specified here
can result in dangerous radiation exposure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• If the machine is not used for an extended period of
time, the batteries should be removed.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
Additional safety instructions
m ATTENTION!
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain conditions. In order to
prevent the risk of serious or deadly injuries, we recom-
mend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the machine.
Attention! The FS3600 Tile Cutter may only be op-
erated with the 10 mA PRCD (residual current circuit
breaker) installed at the factory.
• Wearing personal protective equipment is essential
for all work with the machine.
• Always wear protective goggles to avoid eye injuries.
• Be sure to wear a hair net or a suitable work cap if
your hair is long enough.
Laser class 2
www.scheppach.com
• Wear tight-fitting work clothing. The rotating tool
could catch sleeves or the like.
• Never remove chips or dust with your bare hands.
• When the machine is switched off, it is best to re-
move chips or dust with a hand brush or paintbrush.
• Check that the protective devices function correctly
before starting work.
• Do not overload the machine, they work better and
safer in the specified power range.
• Use the correct tool and make sure that the tools
(cutting wheel) are not blunt or damaged in any way.
• Always lead the cable backwards away from the
machine. Protect any cables from heat, oil and
sharp edges.
• Unplug the mains plug during repairs and mainte-
nance and when machine not in use.
• Work on electrical equipment may only be carried
out by a qualified electrician. Only original parts
may be used.
• Clean workstations make it easier to work.
• Pay attention to what you are doing. Remain sensi-
ble when working.
• Make sure that the substructure can support the
weight of the machine and is sufficiently stable. It
must be ensured that no vibrations can occur during
work.
• To protect against corrosion, all bare parts of the
machine are heavily greased at the factory. Clean
the machine with a suitable environmentally friendly
cleaning agent before commissioning.
• The machine must not be used to machine mate-
rials that are hazardous to health or that generate
dust, e.g. wood, Teflon etc.
• Do not use the machine in the vicinity of combus-
tible fluids or gases.
• Only use the machine in suitable rooms and do not
expose the machine to moisture or humidity.
• Always ensure good lighting when working.
• Do not use the mains cable to pull the connector out
of the socket.
• Always use sharp and clean tools.
• In the event of dangerous situations or technical
faults, switch off the machine immediately and dis-
connect the mains plug.
• In case of damage, do not continue working with the
machine and disconnect the mains plug.
• Only tool attachments and accessories approved by
the manufacturer may be used. The use of non-ap-
proved parts poses a considerable danger of injury.
• Always keep the work area clean and orderly. Dirt
and disorder in the work area can cause accidents.
GB | 27