Hardware Installation - TRENDnet TEW-511BRP User Manual

3. Hardware Installation

Front Panel
The front panel provides LED's for device status. Refer to the following table for the meaning of each feature.
The Power LED lights up and will keep while the Router is powered on. When the Router goes through
Power its self-diagnostic mode during every boot-up, this LED will flash. When the diagnostic is complete, the
LED will be lit continuously.
The DMZ LED indicates when the DMZ function is being used. This LED will remain lit as long as DMZ
DMZ
is enabled.
11a The 11a LED flashes when there is a successful Wireless-A connection.
The 11g LED flashes when there is a successful Wireless-G connection.
11g
LED 1, 2, 3, 4. These numbered LEDs, corresponding with the numbered ports on the Router's rear
panel. If the LED is continuously lit, the Router is successfully connected to a device through that port.
Ethernet
A flashing LED indicates network activity over that port.
Internet The Internet LED lights up when there is a connection built through the Internet port.
User's Guide 5