TRENDnet TEW-455APBO User Manual page 39

Note that VLAN ID in the WDS MAC List setting will only be tagged to egress packets on the wired Ethernet port. Ensure to
match VLAN ID used on the network of the peer. WDS link won't carry tags at all.
WMM: By default, it's "Disable".
Select "Enable", then packets with WMM QoS will take higher priority.
WMM prioritizes traffic according to four Access Categories (AC) ‐ voice, video, best effort, and
background. However, it does not provide guaranteed throughput. Packets with QOS header including
Diffserv/IP TOS and 802.1p will be mapped into 4 Access Categories of WMM, packets without QOS header
will be assigned to Best Effort queue, see table below. 802.1p/IP TOS mapping to WMM:
Data Transmitted
Queue
Clients to AP
AC_BK Background.
AC_BE Best Effort
AC_VI Video
AC_VO Voice
Security Type: Options are "Disabled", "WEP", and "AES" from the drop‐down list. All devices need to have
the same security setting to build WDS link.
WEP Key: Enter HEX or ASCII WEP key at different length as shown below. This system supports up to
4 sets of WEP keys.
IP 802.1P
Priority Description
TOS Priority
0x08
1, 2 Low
0x20
0, 3 Medium
0x28
4, 5 High
0xa0
0x30
0xe0
6, 7 High
0x88
0xb8
TEW‐455APBO High Power Wireless Outdoor PoE Access Point
High throughput. Bulk data that requires maximum
throughput and is not time‐sensitive is sent to this
queue (FTP data, for example).
Medium throughput and delay. Most traditional IP
data is sent to this queue
Minimum delay. Time‐sensitive video data is
automatically sent to this queue
Time‐sensitive data like VoIP and streaming media are
automatically sent to this queue
36
User Manual