Wireless Router user's manual
Management
This screen enables you to set up SNMP and remote management features.
The following functions are covered in this section:
•
SNMP
•
Remote Management
SNMP
This screen enables you to configure SNMP.
Enabled/Disabled: Click to enable or disable SNMP.
System Name: Displays the name given to the router.
System Location: Displays the location of the router (normally, the DNS name).
System Contact: Displays the contact information for the person responsible for the router.
Community: SNMP system name for exchanging SNMP community messages. The name can be used to limit
SNMP messages passing through the network. The default name is 'public.'
Trap Receiver: Type the name of the destination PC that will receive trap messages.
Remote Management
This screen enables you to set up remote management. Using remote management, the router can be config-
ured through the WAN via a Web browser. A user name and password are required to perform remote
management.
HTTP: Enables you to set up HTTP access for remote management.
•
Enable: Click to enable or disable HTTP access for remote management.
•
Remote IP Range: Type the range of IP addresses that can be used for remote access.
– 48 –