TRENDnet TEW-311BRP User Manual page 55

The rule profiles are listed in the table at the bottom of the page.
When selecting items in the table at the bottom, click
anywhere in the item. The line is selected, and the
fields automatically load the item's parameters, which
you can edit:
Note!
Enable: Click to enable or disable the firewall rule profile.
Name: Type a descriptive name for the firewall rule profile.
Action: Select whether to allow or deny packets that conform to the rule.
Inactive Timeout: Type the number of seconds of network inactivity that elapse before the router refuses the
incoming packet.
Source: Defines the source of the incoming packet that the rule is applied to.
•
Interface: Select which interface (WAN or LAN) the rule is applied to.
•
IP Range Start: Type the start IP address that the rule is applied to.
•
IP Range End: Type the end IP address that the rule is applied to.
Destination: Defines the destination of the incoming packet that the rule is applied to.
•
Interface: Select which interface (WAN or LAN) the rule is applied to.
•
IP Range Start: Type the start IP address that the rule is applied to.
•
IP Range End: Type the end IP address that the rule is applied to.
•
Protocol: Select the protocol (TCP, UDP, or ICMP) of the destination.
•
Port Range: Select the port range.
Add: Click to add the rule profile to the table at the bottom of the screen.
Update: Click to update information for the rule if you have selected a list item and have made changes.
Delete: Select a list item and click Delete to remove the item from the list.
New: Click New to erase all fields and enter new information.
Priority Up: Select a rule from the list and click Priority Up to increase the priority of the rule.
Priority Down: Select a rule from the list and click Priority Down to decrease the priority of the rule.
Update Priority: After increasing or decreasing the priority of a rule, click Update Priority to save the changes.
Click anywhere in the line to select it.
– 47 –