Flanger - E-Mu 1212M Owner's Manual

5 - Effects
Core Effects Descriptions

Flanger

A flanger is a very short delay line whose output is mixed back together with the original
sound. Mixing the original and delayed signals results in multiple frequency cancella-
tions known as a comb filter. Since the flanger is a type of filter, it works best with
harmonically rich sounds.
A low frequency oscillator is included to slowly change the delay time. This creates a
rich, sweeping effect as the notches move up and down across the frequency range. The
amount of feedback deepens the notches, intensifying the effect. You can invert the
feedback signal by choosing a negative feedback value. Inverting the feedback signal
creates peaks in the notch filter and deepens the effect.
Feedback
In
Flanger
Delay
Parameter Description
Delay Sets the initial delay of the flanger in .01 millisecond increments.
This parameter allows you to "tune" the flanger to a specific
frequency range. Range: .01ms to 4ms
Feedback Controls how much signal is recirculated through the delay line
and increases resonance. Negative values can produce intense
flanging with some signals. Range 0% to 100%
LFO Rate Sets the speed of the flanger sweep. Range: .01 Hz to 10Hz
LFO Depth Sets how much the LFO affects the delay time. Increases the
animation and amount of the flanging effect. Range 05 to 100%
LFO Waveform Selectable between Sine or Triangle wave.
LFO L/R Phase Controls the stereo width by adjusting the phase difference
between the left and right sweeps. Range: -180° to +180°
70
Out
LFO
Phase
Waveform
Creative Professional