Output Section; Main Inserts; Main Output Fader; Output Level Meters - E-Mu 1212M Owner's Manual

Output Section

Clip Indicators
Main
Insert
Section

Main Inserts

The main inserts allow you to apply effects to the main stereo signal coming out of the
mixer (both mains and monitor). You might want to apply EQ or a compressor here.
These inserts work just like the other insert locations—just drag and drop effects from
the palette or right-click and add Sends, Sends/Returns. etc.
Diagram

Main Output Fader

The main output fader controls the level of the main output (and the Monitor output as
well since it is downstream from this control). The normal setting for this control is at
unity or 0dB, but the control allows you to add up to +12dB of gain. High output levels
may cause clipping on outboard amplifiers or other equipment.

Output Level Meters

This stereo bar-graph meter reflects the digital level at the output of the mixer. The
topmost red bar represents 0 dB or a full-scale digital signal. The peaks hold for a
moment so that short transients can be monitored. Each bar = 1dB.

Monitor Output Level

This control adjusts the monitor output level. Keep in mind that since the monitor level
control comes after the Main Output Fader, nothing will be heard from your monitors if
the main level is turned down.

Monitor Balance Control

This control sets the relative volume of the stereo monitor outputs and works just like
the balance control on your home music system. This control is primarily used to make
the volume from each speaker sound equal if you are not sitting exactly in the center of
the two speakers.

Monitor Output Mute

This button completely cuts off the monitor output and provides a convenient way to
instantly kill all sound without having to re-adjust the monitor level later. When the
telephone rings, just hit the monitor mute to cut the noise.
E-MU Digital Audio System
Main Output Level Fader
Monitor
Output Level
Volume
Meters
Sync/Sample
Rate Indicators
Monitor
Mute
Monitor
Balance
Refer to the Mixer Block
4 - The PatchMix DSP Mixer
Main Section
MAIN MIX
0dB
10 10
-12dB
20 20
30 30
40 40
50 50
L R
f Hot Tip: The System
Volume Control on your
Mac or PC can be used to
control the Monitor
Output Level on
PatchMix.
53