Using External Sends & Returns - E-Mu 1212M Owner's Manual

4 - The PatchMix DSP Mixer
Mixer Strip Creation
Choose one of the Send Outputs. Click on a destination to select it.
3.
Choose one of the Return Inputs. Click on a source to select it.
4.
Click OK to select the Send and Return, or Cancel to cancel the operation.
5.
Using External Sends & Returns
An External Send/Return breaks the signal at the insert point and sends it out to the
selected external destination such as a compressor, a stereo effect processor or any other
audio device. Any physical input or output can be used.
The Send/Return Inserts allow you to connect your favorite external analog or digital gear.
To Insert an External Signal Processing Device:
Right-click on the insert chain and select the Insert Send/Return (Physical Output
1.
and Input). The popup dialog box shown above appears.
Select the output and input you wish to use.
2.
Connect your external audio gear to the appropriate analog or digital connectors.
3.
If you're using the analog outputs and inputs, you may have to adjust the levels in
4.
the I/O Session Settings.
Return to make sure you're getting a strong signal back from the external device.
If you're using a digital Send/Return, make sure that the external digital device is
5.
synchronized to the digital input. Otherwise, poor audio quality will result.
(Alternatively, you can synchronize PatchMix DSP to your external device in the System
Session Settings. See page
40
Insert
Send/Return
Outboard Signal Processor
See page 33. You can insert a level meter after the Send/
32.)
Input
To Physical Output
From Physical Input
Panning
Fader
Aux 1 Bus
Aux 2 Bus
Main Output Bus
S/PDIF
Input
S/PDIF
Output
If the source or
destination you want to
use is not available in the
list, they are probably
already being used
elsewhere. Check the
input Strips, Inserts and
Output Assignments.
Creative Professional