E-Mu 0202 & Audiodock - E-Mu 1212M Owner's Manual

E-MU 0202 & AudioDock
If you have both the E-MU 0202 I/O card and the AudioDock, you are advised not to
connect both to the same E-MU 1010 PCI card using this version of software. There are
known issues with doing this what will be addressed in a future software update.
AudioDock Owners only
Locate the Disk Drive Power Converter Cable shown below and identify the large
5.
male connector (the one with pins on it). Plug this connector into a spare disk drive
power cable in your computer. If there is no spare disk drive power cable, insert the
Adapter Cable between one of your disk drives and the power supply.
Power Converter Cable
To Disk Drive
E-MU 1010 PCI Card
Plug the small connector into the E-MU 1010 PCI card as shown above. The
6.
connector is keyed and can only be inserted one way.
After all components have been installed and securely fastened, close the computer
7.
case.
Connect the supplied network-type cable from the 10 BaseT jack on the E-MU 1010
8.
PCI card labeled "EXTERNAL" to the matching connector labeled "Card" on the
AudioDock. The cable supplied with the AudioDock is specially shielded to prevent
unwanted RF emissions.
Plug the power cord back into the wall outlet and turn on your computer.
9.
E-MU 1820M/1820/1212M PCI Digital Audio System
Install the Sync Daughter Card or 0202 Daughter Card
To Power
Supply
2 - Installation
The AudioDock
requires 1.1 Amps at 12V
(13 Watts) to operate.
The AudioDockM requires
1.25 Amps at 12V (15
Watts) to operate.
CAUTION: Do not
connect the supplied
CAT5 cable to the
Ethernet or network
connector on your
computer. Doing so may
result in permanent
damage to either your
computer, the E-MU 1010
or both.
15