Table of Contents
Advertisement
Chapter 4
Dish Antenna Installation
Azimuth:
Elevation:
Page 92
2. Select the satellite your dish will be pointed toward.
3. Select
under the
300
4. Use the number buttons on the remote to enter your ZIP code to get the
necessary azimuth and elevation. Write these numbers down in the spaces
provided in the margin.
5. Mount the dish antenna and multi-dish switches following the mounting
instructions that came with them and the DISH Pro Wiring Diagrams starting on
page 94.
6. Connect two RG-6 cables from both S
to two available ports on the switch(es).
7. Connect the LNBF on the dish antenna to LNBF port 1 on the switch(es) using
RG-6 cable.
8. Select
Check Switch
screen opens, select
9. When
Check Switch
similar to the one shown next. It will show a connection ("Conn" next to
satellite) and
Single
Transponder line. This is okay and does not mean there is a problem with the
system.
10. Press CANCEL to exit back to the Point Dish menu.
11. Point the dish for the strongest possible signal, following the instructions that
came with it.
.
Dish System
ATELLITE
from the
menu. When the
Point Dish
.
Retest
is complete, you will see an
device under 1 (Dish Input). It may also show an X on the
I
connections on the receiver
N
Check Switch
Installation Summary
screen
Hide quick links:
Advertisement
Table of Contents
