Dish Network 322 User Manual page 94

Chapter 4
Dish Antenna Installation
19. When the signal strength bar is green, turn the dish back and forth just a little, to
20. You are now ready to verify reception from both satellites. Select the Check
21. If you do not see
22. Look at the Point Dish menu. If you have good signal strength with
Page 90
: If you cannot find the signal, turn the dish back to the first azimuth angle.
Note
Then, loosen both elevation bolts just enough so you can tilt the dish. Tilt the
dish elevation up by two degrees, and then tighten both bolts. Now, turn the dish
back and forth again. If you still can't find the signal, tilt the dish up again very
slightly and turn the dish back and forth until you find the signal. Do not change
the skew setting.
where the signal strength bar shows the strongest signal. When you find the
strongest signal, tighten both mast clamp bolts. Then loosen both elevation
bolts, just enough so you can tilt the dish. Tilt the dish up and down just a little,
to where the signal strength bar shows the strongest signal. When you find the
strongest signal, tighten all bolts in the dish assembly so the dish cannot be
moved.
Switch option. When the Check Switch menu opens, select Retest. The
receiver shows you a message that it is checking the system. When the
procedure is finished, you will see an Installation Summary screen. This
screen may look different than the one shown below.
• Satellite - in
119 Port 1
• - twice. This is OK and does not indicate a problem with
Transponder All
the receiver.
Device Type -
•
Twin
the connection with your DISH Pro Twin LNBF is working. Press OK to
exit this menu."
• -
Status Satellite reception verified
under
110
• Make sure the skew angle you wrote down on page 86 is exactly the same as
the skew angle you set in step 5 on page 87. If it is not, reset the skew angle
as described on page 87. After you reset the skew angle, go back page 89
and start over from step 16.
• If is shown under
119
and restart the procedure at step 12.
119 is indicated by a green signal bar, select 110. If you have good signal
strength on 110, go to step 23.
and in .
110 Port 2
twice. This indicates that your receiver has confirmed
.
:
Port 2
, move the dish approximately 9° to the east
Port 2