Connecting The Receiver To A Nearby Tv - Dish Network 322 User Manual

Attention
very well from far away, you may be experiencing
interference from objects near your receiver. To improve your
remote control's range, try any or all of the following:
• Place the receiver higher than all of the other equipment in
your entertainment center.
• Provide room above the receiver so that the antenna can be
installed straight up. If this is not possible, tilt the UHF
antenna at about a 30° angle.
• Place the UHF antenna outside the entertainment center by
using a coaxial cable to connect the antenna to the receiver.
• Try moving the receiver to other locations.
• Attach a UHF attenuator to the
33).

Connecting the Receiver to a Nearby TV

This section describes how to connect receiver
TV. The easiest way to connect the receiver to the TV is using coaxial cable
connections, but you may also use
Coaxial Cable Connections (TV1)
1. Connect a coaxial cable from the
the nearby TV's tuner port.
2. Place the white
connects to the receiver (see the picture in the margin).
3. Plug in the power cord for the receiver.
4. Turn on the receiver with the front panel power button and make sure
the green TV1 indicator is lit.
: If your UHF Pro Remote Control 2 isn't working
or
RCA
CH 3-4 OUT
sticker on the cable near where the cable
CH 3-4 OUT
Connecting the Receiver to a Nearby TV
R A
EMOTE NTENNA
output ports to a nearby
TV1
outputs.
S-Video
output on the receiver to
port (see
Tip: Using cable
labels makes it easy
to tell which cables
connect to the
receiver ports.
Inside the front
cover of this guide
are stickers that are
color coded the
same way as the
coaxial
connections.
Page 19