Dish Network 322 User Manual page 116

Chapter 5
Reference
What Is Happening
You set up an event timer, • The program time may have
but the timer does not
operate at all.
You set up a Once event • The program time changed.
timer, but the timer operates
at a time different from what
you expect.
You stop the operation of an • Stopping the event timer applies
event timer for one showing
of a program that is repeated
(such as a regularly
scheduled program), but the
timer operates for the next
showing.
You are testing a VCR code • The VCR may not be turned ON,
to see if the receiver controls
a VCR. The VCR does not
do the test.
Page 112
Possible Reason
changed so that the event timer
overlapped another event timer.
The program time may have
changed by more than twenty-four
hours.
only to the current showing of the
program.
there may not be a tape inserted,
the tape may not be rewound, or the
write-protect tab on the tape may
have been removed.
The code you are testing may not
be valid for the VCR.
What to Do
• If the receiver is ON and finds an event timer overlap, it will
display the Event Timer Scheduling Conflict menu. You
must edit or delete one of the overlapping event timers.
No event timer will operate if the program time changes by more
than twenty-four hours.
• A Once event timer always operates at the actual time of the
program.
• To stop all operations of a repeated event timer, you must delete
the event timer.
Note: The receiver deletes a Once event timer when it operates.
• Make sure the VCR is turned ON, with a blank tape inserted on
which you want to record, that the tape is rewound, and that the
write-protect tab on the tape is intact.
Try another VCR code from the VCR Codes table.