Osd Warning Messages - Low Battery; Osd Warning Messages - Out Of Range; Combinations Of Buttons - Dell S500 User Manual

2
Left
3
Function
4
Mini USB charge
connector
5
LED indicators
6
Right
7 Power switch
8
Firmware upgrade
connector

OSD warning messages - low battery

• The Low Battery warning message pops up when the battery voltage is
lower than 2 V. At this condition, the pen can still work about 1~2 hours.
• The pen will be disabled when the battery voltage is lower than 1.8 V.

OSD warning messages - out of range

The situations below may cause the pen sensor out of range:
• The pen doesn't point toward the screen.
• The pen is too far away from the screen.
• The projector's brightness is too low for detection.

Combinations of buttons

• Right + Function (for Master Pen only): The Slave Pen set function
menu appears on the screen.
• Left + Function: The Pen Information menu appears on the screen.
• Hold Function: Hold the Function button for 2 seconds and the
Function mean will appear on the screen. Use Left/Right to move
up/down and use Function to enter/apply.
40 Using Your Projector
This button acts like the left click button of a
mouse.
Functions available are listed in the OSD Menu
"Set function" (see page 70).
NOTE:
Double-clicking the Function button
will act as Undo, if supported by the
software.
Allow you use Mini USB cable to charge. See
"Charging the Interactive Pen Battery" on
page 44.
Two LED indicators are available: Green and
Amber (see on "Interactive Pen LED Guiding
Signals" on page 115).
This button acts like the right-click button of a
mouse.
Turns the Interactive Pen on or off.
For Interactive Pen and RF board firmware
upgrade.