Dell S500 User Manual page 60

2. Enable the 3D function when it satisfies any of the below-mentioned
conditions:
a
b
3. "3D Display" selection will only be enabled in the "Display Settings of
the Advanced Settings" menu when the projector detects either of
the inputs mentioned above.
4. 3D support and refresh rate are as below:
a
b
c
5. The recommended VGA signal for laptop is Single-mode output
(Dual mode is not recommended).
3D S I
YNC
DLP 3D goggles, you may need to execute 'Invert' to get best match of
left/right image sequence to get the correct image. (For DLP 3D goggles)
P S
ROJECTOR ETTINGS
projector settings menu provides the following options:
A S
UTO OURCE
you press the Source button when the Auto Source mode is set to Off, you
can manually select the input signal. Select On to auto detect the available
input signals. If you press the Source button when the projector is on, it
automatically finds the next available input signal.
P
ROJECTOR
upon how the projector is mounted.
•Rear Projection-Desktop — The projector reverses the image so that you
can project from behind a translucent screen.
60 Using Your Projector
Computer/Laptop with graphics card, capable of outputting at
120 Hz signal via VGA or HDMI cable.
Input a suite of 3D content via Video and S-Video.
VGA/HDMI 1280 x 720 120 Hz, 1024 x 768 120 Hz and 800 x 600 120 Hz
Composite/S-Video 60 Hz
Component 480i
—
If you see a discrete or overlapping image while wearing
NVERT
—
Select and press
—
Select Off (the default) to lock the current input signal. If
M —
Allows you to select the projector mode, depending
ODE
to activate projector settings. The