Dell S500 User Manual page 58

3D D —
ISPLAY
NOTE:
1. When you want to create a 3D experience, you will need a few other
components including:
a
b
c
d
2. Enable the 3D function when it satisfies any of the below-mentioned
conditions:
a
b
3. "3D Display" selection will only be enabled in the "Display Settings of
the Advanced Settings" menu when the projector detects either of
the inputs mentioned above.
4. 3D support and refresh rate are as below:
a
b
c
5. The recommended VGA signal for laptop is Single-mode output
(Dual mode is not recommended).
3D S I
YNC NVERT
DLP 3D goggles, you may need to execute 'Invert' to get best match of
left/right image sequence to get the correct image. (For DLP 3D goggles)
58 Using Your Projector
Select On to start the 3D display function (default is Off).
Computer/Laptop with a 120 Hz signal output quad-buffered
graphics card.
"Active" 3D glasses with DLP Link™.
3D content. See "Note 4".
3D Player. (Example: Stereoscopic Player...)
Computer/Laptop with graphics card, capable of outputting at
120 Hz signal via VGA or HDMI cable.
Input a suite of 3D content via Video and S-Video.
VGA/HDMI 1280 x 720 120 Hz, 1024 x 768 120 Hz and 800 x 600 120 Hz
Composite/S-Video 60 Hz
Component 480i
—
If you see a discrete or overlapping image while wearing