Dell S500 User Manual page 65

c
3. After the IP Address, Subnet Mask, Gateway, and DNS is set up,
select Store and press
4. If you select Store without pressing the Enter button, the system will
keep the original settings.
M S —
ENU ETTINGS
settings consists of the following options:
M P
ENU OSITION
the screen.
M T
ENU IMEOUT
default, the OSD disappears after 20 seconds of non-activity.
M T
ENU RANSPARENCY
background.
M L
ENU OCK
Select Off to disable the Menu Lock. If you want to disable the Menu Lock
function and have the OSD disappear, press the Menu button on the
control panel or remote control for 15 seconds, and then disable the
function.
P
ASSWORD
requesting you to enter a password will be displayed when the power plug is
inserted into the electrical output and the power for the projector is first
turned on. By default, this function is disabled. You can enable this feature,
by selecting Enabled. If the password has been set before, key in the
password first and select the function. This password security feature will
be activated the next time you turn on the projector. If you enable this
feature, you will be asked to enter the projector's password after you turn
on the projector:
First time password input request:
1
After the setup is complete, press the
Select and press
—
Allows you to change the position of the OSD menu on
—
Allows you to adjust the time for an OSD timeout. By
—
Select to change the transparency level of the OSD
—
Select On to enable Menu Lock and hide the OSD menu.
—
When Password Protect is enabled, a Password Protect screen
button to store the settings.
to activate the menu settings. The menu
Using Your Projector
button to exit.
65