Dell OptiPlex GXi Systems Service Manual
4-10
Hard-Disk Drive Assembly
captive screw
front of computer
Figure 4-8. Hard-Disk Drive Assembly Removal
To remove the hard-disk drive, follow these steps:
1. Disconnect the DC power cable and the interface cable from the back of
the drive.
2. Loosen the captive screw that secures the hard-disk drive bracket to the
chassis.
3. Pivot the hard-disk drive assembly up, then lift it out of the chassis.
4. Remove the four hard-disk drive mounting screws that attach the hard-
disk drive to the hard-disk drive bracket.
When you reinstall the hard-disk drive assembly, be sure the tabs on the back of
the mounting plate fully engage in the notches on the chassis before you rotate
the assembly into place.
hard-disk drive
mounting screws (4)
tabs
notches