Dell OptiPlex GXi Systems Service Manual
6-8
C
ontrol Panel
control-panel cable
Figure 6-6. Control-Panel Removal
To remove the control panel, follow these steps:
1. Remove the hard-disk drive bracket.
2. Disconnect the control-panel cable from the PANEL connector on the
system board (see Figure 6-15).
3. Remove the mounting screw holding the control panel to the chassis.
4. Slide the control panel out of the hooks holding it to the chassis.
Note the routing of the control-panel cable as you remove it from the
chassis.
chassis hooks (2)
control panel
screw