Icom IC -2410A Instruction Manual page 29

usme SET MODE
e SETTING A RESUME
CONDITION
1)
2)
3)
Push [SET] several times until "SC" appears on the
function display as shown above.
e Refer to p. 11 for SET mode details.
Rotate the tuning control to set the desired timer.
eSCt-5 : Scan resumes 5 sec. after the scan pauses.
e SCt-10 : Scan resumes 10 sec. after the scan pauses.
e SCt-15 : Scan resumes 15 sec. after the scan pauses.
eSCP-2 : Scan pauses until a signal disappears and
resumes after 2 sec.
e SCt-EP : Scan pauses at a frequency that is not busy
and resumes 2 sec. after a signal appears.
It is useful to find a blank channel.
Push any switch except [SET] and [HI/LOW] to set the
condition and to exit SET mode.
V/U separate setting
uses SET MODE
e SETTING A MEMORY
SKIP CHANNEL
4)
MEMORY mode — SET mode
V/U separate setting
Push [M/CALL] until "M" and a memory channel number
appear on the function display to select MEMORY mode.
Select the memory channel to be set as a skip channel.
e The memory channels "A" and "b" cannot be set as a
skip channel.
Push [SET] several times until "-CH-" blinks on the
function display.
* Refer to p. 11 for SET mode details.
Rotate the tuning control to illuminate the skip
indicator.
e"SKIP": The memory channel is skipped during
memory scan.
e" ": The memory channel is scanned during
memory scan.
Push any switch except [SET] and [HI/LOW] to set the
condition and to exit SET mode.