Icom IC -2410A Instruction Manual page 17

6) Push [V/MHz] to select VFO mode when another
mode has been selected.
7) Set the operating frequency using the tuning
control or [UP] and [DN] on the microphone.
e See p. 12 for more information.
e See p. 15 for accessing the SUB band and setting a
frequency.
8) When receiving a signal on the set frequency:
e Squelch opens and the transceiver emits audio.
e "BUSY" appears.
e The S/RF indicator shows relative signal strength.
e SUB band mute or SUB band busy beep is useful for
dual band receiving. (p. 15)
B RF attenuator
The 20 dB RF attenuator does not allow receiving of
weak signals. This attenuator, therefore is useful for
short-distance contact since undesired long-distance
signals will be eliminated. |
Push and hold [HI/LOW] until "ATT" appears.
e To cancel the function, push and hold [HI/LOW] until "ATT"
disappears.
* The function can be automatically turned ON with output
power selection. See at right.
BASIC OPERATION 4
uswa SET MODE
* AUTOMATIC RF ATTENUATOR
The RF attenuator function can be automatically turned
ON when the low power 1 is selected.
1) Push [BAND] to select VHF or UHF.
e Refer to p. 11 for SET mode details.
3) Rotate the tuning control to set the condition.
e "Att.- - -" : Automatic RF attenuator OFF
"Att.Aut": Automatic RF attenuator ON
4) Push any switch except [SET] and [HI/LOW] to set the
condition and to exit SET mode.