Advertisement
Control D2D, Continued
P
1. To configure your Smart Lock as a controller,
press and hold the SET button for 5-10 seconds
until you hear "Device to Device Pairing Mode,"
then release the button.
2. To configure a Siren as the responder, press
and hold the SET button for 5-10 seconds until
the LED quickly blinks green, then release the
button.
3. Upon pairing, the LED will stop blinking (this
may happen after only blinking two or three
times). When the door is unlocked, the Siren will
alarm.
SET Button
5-10 seconds
SET Button
5-10 seconds
38
Advertisement
Need help?
Do you have a question about the YS7617-UC and is the answer not in the manual?