Table of Contents
Advertisement
contains no data path loops. Between any two ends nodes, there should be only
one active cabling path at any time. Data path loops will cause broadcast storms
that will severely impact your network performance.
Diagnosing LED Indicators
The Switch can be easily monitored through panel indicators to assist in
identifying problems, which describes common problems you may encounter and
where you can find possible solutions.
If the power indicator does turn on when the power cord is plugged in, you may
have a problem with power outlet, or power cord. However, if the Switch powers
off after running for a while check for loose power connections, power losses or
surges at power outlet. If you still cannot resolve the problem, contact your local
dealer for assistance.
Cabling
RJ-45 ports: use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cable
for RJ-45 connections: 100Ω Category 3, 4 or 5 cable for 10Mbps connections or
100Ω Category 5 cable for 100Mbps connections. Also be sure that the length of
any twisted-pair connection does not exceed 100 meters (328 feet). Gigabit port
should use Cat-5, Cat-5e, or Cat-6 cable for 1000Mbps connections. The length
does not exceed 100 meters.
110
Advertisement
Table of Contents
