Ip Qos - TRENDnet TDM-C500 User Manual

Apply Changes
Save configuration to system. New configuration will take effect after saving into flash memory and rebooting
the system. See section "Admin" for details.
The DSL device provides a control mechanism that can provide different priority to different users or data
flows. The QoS is enforced by the QoS rules in the QoS table. QoS rule contains two configuration blocks:
Traffic Classification and Action. The Traffic Classification enables you to classify packets on the basis of
various fields in the packet and perhaps the physical ingress port. The Action enables you to assign the
strictly priority level for and mark some fields in the packet that matches the Traffic Classification rule. You
can configure any or all field as needed in these two QoS blocks for a QoS rule.
Field Description

IP QoS

Enable/disable the IP QoS function.
Source IP The IP address of the traffic source.
Source Netmask The source IP netmask. This field is required if the source IP has been entered.
Source Port The source port of the selected protocol. You cannot configure this field without
entering the protocol first.
Destination IP The IP address of the traffic destination.
Destination Netmask The destination IP netmask. This field is required if the destination IP has been
entered.
Destination Port The destination port of the selected protocol. You cannot configure this field without
entering the protocol first.
Protocol The selections are TCP, UDP, ICMP and the blank for none. This field is required if
the source port or destination port has been entered.
Physical Port The incoming ports. The selections include LAN ports and the blank for not
applicable.
IP QoS
38