Setting Incoming Fax Properties - Captaris FaxPress Supplementary Manual

Admin Guide > Configuring the User Properties
Fax Approval – If you've enabled FaxPress Approval the conditions under which approval
is required are displayed here.
Use the Advanced button to set Advanced Options.
Line section:
Default – use to set a specific line for all of this user's outgoing faxes, or keep the default
Any Line setting to allow the user's faxes to be sent out on any available line.
Baud Rate – set the maximum baud rate for fax transmission.
Retries section:
Number of Retries – set the default maximum number of times the FaxPress will try to
send faxes before returning a failure message.
Time between – set an interval in minutes between each retry attempt.
Resolution section: Select a resolution mode for outgoing faxes.
Standard resolution is 200 X 100 dpi;
Fine resolution is 200 X 200 dpi.

Setting Incoming Fax Properties

The Incoming Faxes tab allows you to set users' incoming fax options.
150